Speer
Hammocks, Inc
Make Your
Own Hammock Kit
Sewing
Tips From Clarissa
These tips include helpful hints and sewing
suggestions from our Chief Seamstress Clarissa Speer. The tips are in addition
to the sewing instructions in the book Hammock Camping, The Complete
Guide to Greater Comfort, Convenience and Freedom, which is also
included with each make-your-own kit. The tips included here are based on
Clarissa's lifetime of sewing experience including many hours of sewing the
specific items and fabrics in the kits themselves. Referring to both the
Hammock Camping book and Clarissa's tips, anyone should be able to easily make
their own hammock using one of these kits. The individual steps below should be
followed consecutively in the order presented.
Thanks for trying one of our hammock kits--you may
never sleep on the ground again! Best of luck with your project and happy
hammocking.
General Information and Equipment
Needed
·
You
will need a Make Your Own Hammock Kit from Speer Hammocks, Inc
·
You
will need a household sewing machine
·
Stitches
used: 1) Straight stitch (see p. 110 of
Hammock Camping book)
2) Bar tack--a satin stitch
or very tight zigzag stitch (see your
sewing manual)
·
Useful
sewing tips can be found in your machine's manual as well as the following web
sites:
· http://www.specialtyoutdoors.com
·
http://www.pages.prodigy.net/shereemckee/fashion.htm
Contents
of Each Kit
Hammock Camping book by Ed Speer
Sewing Tips From Clarissa (this manuscript)
Thread, 100% polyester (be sure to use for both top &
bottom threads)
Hammock Items
·
Fabric,
one piece cut to proper size
·
Velcro
loop fasteners, 2, cut to proper length
·
Webbing
straps, 2 @ 12' ea, ends heat sealed
·
D
rings, 2
·
D
ring attachments, 2 @ 2" length of 1" webbing ea, ends heat sealed
Bug Net Items
·
No-see-um
netting, cut to proper length and width
·
Velcro
hook & loop fasteners for bug net ends:
·
2
hook fasteners @ 11" ea
·
2
loop fasteners @ 11" ea
·
Velcro
fasteners for long edges of bug net
·
2
hook fasteners cut to proper length
·
2
loop fasteners @ 5" ea
·
Support
Line (Pulse Line, shock cord, & snap hook)
·
Spectra
Pulse line cut to proper length, ends heat sealed, orange
·
24"
length of 3/32" shock cord, ends heat sealed, attached to Pulse Line
·
Snap
hook, attached to shock cord
·
Support
line reinforcements, 2 @ 2" of 1" grosgrain ribbon ea, ends heat
sealed
Rain Canopy Items
·
Fabric
(1.1 oz/yd2 silnylon), 2 panels cut to proper size
·
Pull
tabs: (ends heat sealed)
·
Ridge
line tabs: 2 @ 5" ea (1" grosgrain ribbon), w/ grommets pre-installed
·
Corner
& Edge tabs: 8 @ 2" ea (1" grosgrain ribbon)
·
Ridge
line pull tab reinforcements, 2 @ 2"X5" ea (silnylon fabric)
·
Guidelines,
6 @ 10' ea, Spectra Pulse Line, ends heat sealed, orange
Carry Sack
·
Fabric,
cut to proper size
·
Draw
cord, cut to proper length
·
Toggle
Hammock
1.
Choose Fabric Sides.
Some
fabric has a shinny finish on one side, while some fabric is the same on both
sides. If your fabric has different
finishes, decide which you want on the inside and which you want on the outside
of your Hammock. Either works fine, but
shinny side to the inside generally looks nicer. Do not loose tract of your inside/outside
choices while following these instructions.
2.
Sew Hems
·
Hem
both long sides with folded hem to the outside of the Hammock
· Referring to Fig A, first
fold hem 1/2"
· Fold again 1/2" to
secure raw edges
· Sew hem with straight stitch

Fig A
Hem Hammock Fabric--hem all four edges
·
Hem
ends as above (or serge if machine w/ 100% polyester thread is available); this
prevents unraveling later
3.
Attach Velcro (Loop strips will be attached to each long edge of Hammock--Hook
strips are avoided here since they catch user's clothing)

Fig B
Fold Hammock Fabric end to end; mark
center points on each long edge
·
Attach
Velcro Loop strips to the outside of the long edges; if you hemmed the edges as
recommended in Number 2 above, the Velcro strips will now overlie and protect
the hem
·
Determine
center of each long side by folding end to end and mark center point with chalk
or pin (Fig B).
·
Determine
the center of the two long Velcro loop strips by folding end to end and mark
·
For
layout see Fig C

Fig C
Attaching Loop Velcro Strips to Hammock
Match
centers of hammock and Velcro strips
Place Velcro strips 1/2" from edge (to create finger tab)
·
Create
finger tabs between Velcro and edge of Hammock to help separate the Hammock
from the Bug Net--this makes entry and exit from the Hammock easier. Placing Velcro along the inside edge of hem
should give the recommended 1/2" finger tab.
·
Sew
both sides and ends of Velcro loop strips with straight stitch
4.
Tie End Knots following instructions in the book (see p. 122-125 of Hammock
Camping book) This is an important step that is well covered in the book
5.
Attach Hanging Straps (Polypropylene or Polyester webbing; see p. 125-127 and
picture sequence on p. 126 of Hammock Camping book)
·
On
each webbing strap, make attachment loop by folding 6" as shown in Fig D

Fig D
Secure 6" loop in end of Webbing strap with a bar tack
A bar tack is a satin stitch or very tight
zigzag stitch
·
Insert
Hammock end knot thru Webbing Loop and secure webbing with temporary hand stitch
as close to Hammock fabric as possible without stitching to Hammock fabric (Fig
E). Helpful tip: tightly twist Hammock
just below end knot to make it as small as possible (four hands make this
easier than two hands)

Fig E
Place Hammock End Knot thru Webbing Loop and
Secure with hand stitch
·
Next
secure Webbing Loop using zipper foot (the narrow pressure foot) as close as
possible to Hammock. Straight stitch
back and forth 6 or 7 times, then sew a bar tack stitch. Finish with two more bar tacks evenly spaced
(Fig F)

Fig F Completed Webbing Strap
w/ D Ring
6.
Install Bug Net Support Line Attachments (Two D rings & 2" webbing
strips)
·
See
p. 130-134 of Hammock Camping book
·
Referring
to Fig F above, position D ring attachment 12" from Hammock end knot
·
Sew
one end of 2" piece of webbing w/ zigzag bar tack, slip on D ring and sew
other end
·
Repeat
for second D ring on other strap
7.
Your Hammock Is Finished!
·
Test
Hammock following procedures on p. 128 of Hammock Camping book
·
Note
that the unoccupied Hammock should have noticeable sag for proper set up;
stretching the Hammock too tightly between the supports causes uncomfortable
'shoulder squeeze'. Proper set up is often a problem with a new Hammock since
the polypropylene webbing straps stretch considerably the first few hours the
Hammock is used--you may find your butt touching the ground even with the
Hammock strung tight! However, the straps will soon be stretched out and then
set up will become easier.
·
Time
to take a nap! You've earned it!
Bug
Net
1. Sew Hems
·
Hem
all four edges 3/4" folding once
·
Make
all hems on same side of material--this becomes the inside of the finished Bug
Net
·
It
may be helpful to hem the long sides first and then hem the ends
·
For
a neat finished product, DO NOT stretch the Bug Net fabric while stitching
2.
Attach Support Line Reinforcements (Two 2" pieces of grosgrain ribbon)
·
Grosgrain
ribbon reinforcements go on hemmed side of Bug Net
·
Find
center of Bug Net by folding end to end (Fig G); mark w/ chalk or pin
·
Find
center of grosgrain ribbon, mark (Fig G)
·
Position
grosgrain ribbon on Bug Net by matching center markings as shown in Fig G
·
Stitch
all four sides of grosgrain ribbon
·
Repeat
for other end

Fig G Attaching Support Line Reinforcements on
Bug Net
a Fold Bug Net end to end and mark center on long edge
b Fold 2" Grosgrain Ribbon end to end; mark center
c Position Grosgrain Ribbon at center of Bug Net end
3.
Attach End Velcro (11" hook and 11" loop strips on each end of bug
net)
·
Refer
to Fig H. All Velcro goes on hemmed
side of Bug Net
·
Position
11" piece of hook Velcro on one side of grosgrain ribbon and 11"
piece of loop Velcro on the other side; overlapping grosgrain ribbon 1/2"
on each end. There should be approximately
1" of grosgrain ribbon showing (trim Velcro if necessary)
·
Stitch
all four edges of each piece of Velcro
·
Repeat
on other end of Bug Net

Fig H
Position Velcro & Grosgrain Ribbon on end of Bug Net
4.
Attach 5" Velcro Loop Strips (these allow complete closure of the bug net
beyond each hammock end knot)
·
Referring
to Fig I, position 5" Velcro loop strips on opposite sides and opposite
ends of the Bug Net
·
All
Velcro goes on hemmed side of Bug Net (trim Velcro if necessary)
·
Sew
all four sides of 5" Velcro loop strips

Fig I
Velcro layout for Bug Net
Note
the 2" pieces of Grosgrain Ribbon on center line for
Support Line Reinforcements
5.
Attach Long Velcro Hook Strips (Two hook strips are used here since they catch
badly on clothing if they are used on the hammock edges)
·
Referring
to Fig I, position long Velcro hook strips along sides of Bug Net
·
All
Velcro goes on hemmed side of Bug Net (trim Velcro if necessary)
·
Sew
all four sides of both long Velcro hook strips
·
Secure
all Velcro joins with tight zigzag or satin stitch, finishing with straight
stitch over top and middle of zigzag (as shown in Fig I)
6.
Install Bug Net Support Line (Note new improved support line)
·
A
24" length of shock cord now comes attached to one end of the support line
(this prevents over-tightening of the support line during use)
·
Note
that one end of the shock cord comes attached to a snap hook for easy set up
and removal
·
Otherwise,
install following directions on p. 130-134 of Hammock Camping book
Rain
Canopy
·
Follow
the extensive instructions in the book, p. 134-143 of Hammock Camping
book
·
Silnylon
is very slippery; extensive pinning may be helpful (pin holes are self-sealing
and generally do not pose a leaking problem)
·
Note
that the stitched seam is NOT the ridgeline; instead this seam is perpendicular
to the ridgeline. The Rain Canopy
should be set up over the Hammock with the stitched seam perpendicular to the
Hammock
·
Reinforcing
the Rain Canopy fabric by doubling it at each pull tab is recommended--double
corners over 1" or so and sew on the small pieces of silnylon material at
the ridgeline pull tabs
·
Avoid
excessively preforating the silnylon with heavy bar tacks on the pull tabs;
instead, sew several evenly spaced straight stitches and/or use a "box
with X" pattern for extra security
·
The
two 4" ridgeline pull tabs come with 1/4" grommets installed (they
accept hiking pole tips for easy set up as 'A-frame' tarp when needed on the
ground)
·
Attach
the six 10-foot guidelines as shown on p. 140-142 of Hammock Camping
book. Attach guidelines to the two ridgeline pull tabs; attach guidelines to
the four corner pull tabs
·
The
two ridge guidelines will be excessively long for set up over Hammock between
trees. However, this length is needed
when the Rain Canopy is set up as 'A-frame' on the ground
·
Four
extra pull tabs are included (two centered on each side of the Rain
Canopy). However no guidelines are
included for these since they are seldom needed. When strong winds are anticipated, any light limp cord will work
for these guidelines
Carry
Sack
·
Follow
instructions on p. 143-144 of Hammock Camping book
You're
Finished!
Congratulations,
you've just made your own highly functional wilderness shelter! You have every reason to be proud of what
you've done since your Hammock will give you many years of extremely
comfortable outdoor use. Take it on
your next backcountry trip and be the envy of all the ground campers!
Questions?
If
you have any questions or comments, we'd love to hear from you. Contact Clarissa or Ed at:
Speer Hammocks, Inc
34 Clear Creek Road
Marion, NC 28752-6407
(828) 724-4444
Keep
In Touch
Sign up for email delivery by
sending blank email message to:
mailto:Hammock_Camping_News-subscribe@yahoogroups.com
Or find current and past
issues at: http://www.hammockcamping.com/Newsletters/NEWS.htm
Sign up for email delivery by sending blank email
message to:
mailto:Hammockcamping-subscribe@yahoogroups.com
Or find all past messages at:
http://groups.yahoo.com/group/hammockcamping
Happy
Hammocking!
Ed "Not To Worry" Speer
When you have finished with this web page,
click your browser's <BACK> button or click this link to return to http://www.hammockcamping.com